During a private “fly-in” fishing excursion in the Alaskan wilderness, the chartered pilot and fishermen left a cooler and bait in the plane.  

And a bear smelled it.  

This is what he did to the plane.

  more…

1. Measure a piece of wood two times and say the measurement out loud, this will help you remember.                      

2. When working with cement, wet the surface, this will make it stick much better.

3. Never set a ladder on loose gravel or a slippery surface or more than a 30% pitch.

4. When land scapeing always use a pitch so water runs away from the house.

5.When driving a nail, tap it lightly till it will stand by its self, move fingers and gradually hit harder as the nail gets deeper in the wood.

6. Shut the water and gas off at the source before any demo work.

7. Always call 1-800 Dig before you dig anything.

8. If you start something wrong-take the time to fixit or it will end up wrong, or hurt some body.

9. When cutting on a table saw-stand to the inside of the rip fence in case of kickback.

10. If you blow a breaker while cutting with a power tool, make sure you turn the tool off before resetting

     Breaker and give it a few minutes to cool off or it will kick again.

Hi every one , here’s a tip to save you money on PH-  With all the rain were having it’s hard to keep the PH  up.            If the PH is low, the other chemicals will not work ,

After two weeks of rain, my PH  was not even on the scale. I had to use 24lb of PH rise to get it to  7.5  – $30.00

A great way to save money is use bakeing soda ,this will increase the PH just like  PH rise and costs a lot less -almost half the price.

Hey, heres a quick way to get your pool clear.  Use bleach instead of shock.

It”s cheaper and workes in a couple hours

Stir up the bottom and pour in the bleach.  About 1 gallon of bleach for 4,000 gal. of water.

Repeat this the next day if needed

Installing my flat screen – {   part two

 The day was still young after storing my new TV in a safe place. I grabbed a few drop cloths and covered the mantle and surrounding area. I marked out the area to be cut with a level and square, I marked about 8″ bigger than where the new wall studs will be installed. Typical studs run up and down, the new 2″x4″ studs will run side to side. I call them sister studs, there are other names such as, scabs-nailers -blocking -cats and many more names depending on what part of the country  your from. After marking the square I grabbed my more…

 Here are some train wreck home repairs

These people did not have a clue they more…

The recent tragedy of a young woman being kidnapped and more…

Water proofing your basement.
Start by more…

Hello , my name is Bob. I run a Construction co. called Ocean Front Contractors. I added on a addition for more…